home
 
 

FAQ

Signal is cut bellow 0 Volts. What is wrong?

In case a signal in Data Acquisition window and chromatograms is cut below 0 Volts, you probably unchecked the Bipolar option in the Setup dialog of DataApex's converter (INT9, U-PAD, Colibrick...). To fix this, open the Setup dialog of respective converter in the Clarity Configuration and check the Bipolar option again and both positive and negative voltages will be measured.

Send comment20.12.2010
 

Go back  Back to: FAQ
 
Facebook Twitter Youtube  DataApex Clarity
Downloads
HTML navigation
Sitemap
Print
Last updated: 2016-05-13 | webmaster